How to Change a Door on a USPS Mailbox Tenant Door

 

Select Commercial Mailboxes receives a lot of calls from owners of USPS-approved 4C mailboxes and outdoor cluster mailboxes. Replacing your tenant USPS approved cluster mailbox door is simple and quick! Below are some simple steps to changing the door on your Florence Mailbox apartment mailboxes. These steps apply to your USPS cluster mailboxes or your 4C horizontal.

 

Supplies:

You will need a 3/8 nut driver, pick, and hammer.

First, open the locked door and press up on the latch and open both your gates.

 

Next, grab a 3/8 nut driver and loosen the top nut on the door and remove it.

 

 

Then use a pick and hammer to hit the rod out. Tap the top of the rod to remove it and pull it out from the bottom.

 

Next, remove the old door by unlocking the door that needs to be replaced. Then put the new door on and lock it into place.

 

 

 

 

Then, replace the rod and tap it into place.

 

 

 

Finally, put the nut back on and using the nut driver tighten it.

 

 

Replacing your USPS-Approved apartment mailbox is a simple process that only requires two tools. Check out this video below to see how it is done. We hope these simple steps help you replace your 4C and cluster mailboxes.

 

 

To get replacement doors, contact our Customer Specialist Annie Dzubinski @ annie@selectcommercialmailboxes.com or 888-348-9713.